TALBOT MDPE 32mm x 3/4" Push Fit Male Adapter- E6582

SKU:
70040158.1
£7.34 inc. Tax
£6.12 ex. Tax

Description

Talbot push-fit adaptor for connecting 32mm MDPE pipe to 3/4" BSP Male fittings.

The Talbot Push fit joint is a tried and tested method of jointing low, medium and high density polyethylene water pipe, from 16mm to 180mm and their imperial equivalents. The fitting is quick and easy with no nuts to leave undone - simply push the pipe into the joint. The joint's grip and seal on the pipe increases with water pressure and tensile load which means that the pipe will burst or neck before the joint fails.

Using a common body and only two sets of interchangeable components, Talbot Push-fit will connect to metric PE pipes and their imperial equivalents

IMPORTANT NOTE, MOST PLUMBING PRODUCTS ARE STATED AS BSP IMPERIAL THREAD MEASUREMENT WHICH MEANS THAT ACTUAL DIAMETER OF THE THREAD SIZE IS APPROXIMATELY 1/4 INCH LARGER THAN THAT STATED IN BSP TERMS. FOR EXAMPLE THIS 3/4 INCH BSP THREAD ACTUALLY MEASURES APPROXIMATELY 1 INCH IN DIAMETER

Extra Information

*Category*:
Pushfit Fittings
Type:
Male Adapter