TALBOT MDPE 25mm x 3/4" Push Fit Tank Connector- E7248

£10.46 inc. Tax
£8.72 ex. Tax


TALBOT push fit 25mm x 3/4" tank connector has the following manufacturers code TALBOT Push Fit tank connector 25 x 3/4" - Talbot E7248 The Talbot Pushfit joint is a tried and tested method of jointing low, medium and high density polyethylene water pipe, from 16mm to 180mm and their imperial equivalents. The fitting is quick and easy with no nuts to leave undone - simply push the pipe into the joint. The joint's grip and seal on the pipe increases with water pressure and tensile load which means that the pipe will burst or neck before the joint fails. Using a common body and only two sets of interchangable components, Talbot Pushfit will connect to metric PE pipes and their imperial equivalents - IMPORTANT NOTE, MOST PLUMBING PRODUCTS ARE STATED AS BSP IMPERIAL THREAD MEASUREMENT WHICH MEANS THAT ACTUAL DIAMETER OF THE THREAD SIZE IS APPROXIMATELY 1/4 INCH LARGER THAN THAT STATED IN BSP TERMS. FOR EXAMPLE THIS 3/4 INCH BSP THREAD ACTUALLY MEASURES APPROXIMATELY 1 INCH IN DIAMETER

Extra Information

Pushfit Fittings
Pipe Size:
Thread Size:
3/4 Inch BSP
Tank Connector