TALBOT MDPE 20mm x 1/2" Push Fit Male Iron Adapator is available in 10 sizes in this section
- 16mm x 1/2" Talbot Push Fit Male Iron Adapter - Talbot E4342
- 20mm x 1/2" Talbot Push Fit Male Iron Adapter - Talbot E2729
- 20mm x 3/4" Talbot Push Fit Male Iron Adapter - Talbot E6581
- 25mm x 1/2" Talbot Push Fit Male Iron Adapter - Talbot E6580
- 25mm x 3/4" Talbot Push Fit Male Iron Adapter - Talbot E2731
- 32mm x 1/2" Talbot Push Fit Male Iron Adapter - Talbot E6579
- 32mm x 3/4" Talbot Push Fit Male Iron Adapter - Talbot E6582
- 32mm x 1" Talbot Push Fit Male Iron Adapter - Talbot E2732
- 50mm x 1 1/2" Talbot Push Fit Male Iron Adapter - Talbot E3515
- 63mm x 2" Talbot Push Fit Male Iron Adapter - Talbot E3516
The Talbot Pushfit joint is a tried and tested method of jointing low, medium and high density polyethylene water pipe, from 16mm to 180mm and their imperial equivalents. The fitting is quick and easy with no nuts to leave undone - simply push the pipe into the joint. The joint's grip and seal on the pipe increases with water pressure and tensile load which means that the pipe will burst or neck before the joint fails.
Using a common body and only two sets of interchangable components, Talbot Pushfit will connect to metric PE pipes and their imperial equivalents
IMPORTANT NOTE, MOST PLUMBING PRODUCTS ARE STATED AS BSP IMPERIAL THREAD MEASUREMENT WHICH MEANS THAT ACTUAL DIAMETER OF THE THREAD SIZE IS APPROXIMATELY 1/4 INCH LARGER THAN THAT STATED IN BSP TERMS. FOR EXAMPLE THIS 1/2 INCH BSP THREAD ACTUALLY MEASURES APPROXIMATELY 3/4 INCH IN DIAMETER
