The TALBOT Push Fit repair connector PE x PE (sometimes known as a PUSH FIT Repair Coupler) is available in 3 sizes
- 20mm TALBOT Push Fit repair coupler PE x PE - Talbot E7782
- 25mm TALBOT Push Fit repair coupler PE x PE - Talbot E7777
- 32mm TALBOT Push Fit repair coupler PE x PE - Talbot E7778
The Talbot Pushfit joint is a tried and tested method of jointing low, medium and high density polyethylene water pipe, from 16mm to 180mm and their imperial equivalents. The fitting is quick and easy with no nuts to leave undone - simply push the pipe into the joint. The joint's grip and seal on the pipe increases with water pressure and tensile load which means that the pipe will burst or neck before the joint fails.
Using a common body and only two sets of interchangable components, Talbot Pushfit will connect to metric PE pipes and their imperial equivalents