TALBOT 25mm x 22mm Push Fit Adapator Set is allso available in 3 sizes in this section
- 20mm x 15mm Talbot Push Fit Copper Adapator Set - Talbot E4145
- 25mm x 15mm Talbot Push Fit Copper Adapator Set - Talbot E4147
- 25mm x 22mm Talbot Push Fit Copper Adapator Set - Talbot E5182
- 32mm x 28mm Talbot Push Fit Copper Adapator Set - Talbot E5945 (now dis-continued)
The Talbot Pushfit joint is a tried and tested method of jointing low, medium and high density polyethylene water pipe, from 16mm to 180mm and their imperial equivalents. The fitting is quick and easy with no nuts to leave undone - simply push the pipe into the joint. The joint's grip and seal on the pipe increases with water pressure and tensile load which means that the pipe will burst or neck before the joint fails.
Using a common body and only two sets of interchangable components, Talbot Pushfit will connect to metric PE pipes and their imperial equivalents