E2939 - TALBOT MDPE 63mm Metal Extractors - Pair

£57.29 inc. Tax
£47.74 ex. Tax


The TALBOT Push Fit metal extractors are available in 4 sizes all available in this section. For other sizes you can enter the product code shown below into the search above or search using category

  • 20mm TALBOT Push Fit metal extractor - Talbot Product Code E2935
  • 25mm TALBOT Push Fit metal extractor - Talbot Product Code E2936
  • 50mm TALBOT Push Fit metal extractor - Talbot Product Code E2938
  • 63mm TALBOT Push Fit metal extractor - Talbot Product Code E2939

The product is for a bag of two Talbot metal extractors

The Talbot Pushfit joint is a tried and tested method of jointing low, medium and high density polyethylene water pipe, from 16mm to 180mm and their imperial equivalents. The fitting is quick and easy with no nuts to leave undone - simply push the pipe into the joint. The joint's grip and seal on the pipe increases with water pressure and tensile load which means that the pipe will burst or neck before the joint fails.

Using a common body and only two sets of interchangable components, Talbot Pushfit will connect to metric PE pipes and their imperial equivalents

Extra Information

Pushfit Fittings
Pipe Size: