Single 10mm SPEEDFIT TSM10N pipe insert with a free delivery option. The pipe insert is for use when connecting Speedfit Pipe to a compressions fitting. Many, but not all, compression fittings are suitable for use with plastic fittings and pipe. Users should therefore check for compatibility. Compression fittings with short tube stop depth or hard olives should not be used with plastic fittings or pipe.
When using compression fittings with Speedfit pipe, this Standard Pipe Insert (prefix TSM) must be used to withstand the compressive pressure of the olive. The olive must be located within the length of the pipe insert and the pipe fully inserted into the fitting. The connection should not need more than 2 full turns after the olive has gripped the pipe. Copper olives are preferable to brass olives.
Ensure nut and olive are in place before inserting pipe insert.
There are four sizes of SPEEDFIT SUPERSEAL pipe insert to suit different sizes of fitting, manufacturers codes are shown below and are all available in this section
- 10mm SPEEDFIT pipe insert - TSM10N
- 15mm SPEEDFIT pipe insert - TSM15N
- 22mm SPEEDFIT pipe insert - TSM22N
- 28mm SPEEDFIT pipe insert - TSM28N
JG Speedfit is the easy to use, plastic push-fit system suitable for the plumbing of hot and cold water services and heating applications. The flexible piping system provides the ability to significantly reduce installation time without the need for specialist tools. The fittings can be demounted if required, are lead free, and remove the risk of any scale build up. Extensive tests have shown that Speedfit products will withstand temperatures and pressures well in excess of normal working conditions.
This information should be used as product guidance only and should not be used as a replacement for installation instructions. Please ensure to check with manufacturers instructions of all components prior to selection and installation to ensure compatibility and the most up to date product and installation information.